GROHE Sense kit 1 x GROHE Sense Guard smart water controller + 3 x GROHE Sense smart water sensor

Welcome to GROHE Sense – the innovative water control system that is a real life-changer. This kit includes GROHE Sense Guard – a device installed in the pipework that automatically shuts off water in case it detects an emergency – and three GROHE Sense sensors that detect flooding in spaces where water is used such as kitchens and bathrooms. All devices are connected via WLAN to your smartphone so you can manage your home water system using the intuitive GROHE Ondus app. The GROHE Sense Guard's Aquablock function shuts off the water automatically if a pipe bursts*. Even micro leaks** – which can go unnoticed for a long time and lead to lasting damage – are identified. That means total peace of mind even when you are away from home or on holiday! The smart Aqua IQ function learns your patterns of water consumption and detects anomalies***. AquaTrack generates a comprehensive picture of your household usage. The risk of frost damage is reduced as GROHE Sense Guard also assesses water temperature and alerts you if it may freeze. If there is a power failure, however, the system will not shut off the water in case it is still needed and if the WLAN drops it still operates perfectly. For a qualified installer, fitting GROHE Sense Guard is a simple job using the wall-mount set (22501000). It takes only about an hour. The three battery-powered GROHE Sense devices protect vulnerable parts of your home. Just place them on the floor near the potential source of leakage to detect flooding. The GROHE Ondus app is the hub of the system. It takes seconds to download and gives you instant control, allowing you to monitor your water supply, customize your settings and turn off the water manually. Additionally, with the Nest® Home/Away Assist function, GROHE Sense Guard will even turn off your water supply automatically whenever you leave home and turn it on again when you return. The GROHE Sense Kit – stops leaks and reduces water damage to the minimum! * GROHE defines a pipe burst as a complete hole or a crack in the downstream piping system, resulting in an unintended disposal of water with close to maximal flow rate. Pipe burst detection depends on the general water usage profile, therefore time-lag to shut-off can vary significantly. During that time water might be disposed. Achieve higher detection speed by combining the installation with GROHE Sense on critical locations. ** A micro leak test is conducted once every 24 hours. Pipe material, volume and other piping system characteristics can impact the result. Micro leak detection is limited to the cold water system in most cases. Combine with GROHE Sense to monitor potential humidity increase over time. *** Detection speed depending on the water usage profile in the house. Achieve higher detection speed by combining the installation with GROHE Sense on critical locations.